The Stinger CH38 Cap Hammer is an airless cap system that delivers the holding power of a cap with the speed and ease of a hammer tacker. The Stinger CH38 delivers a 1 in. plastic cap with a 3/8 in. staples. The STINGER CH38 is for use with the 3/8 in. Stinger StaplePac only.

Easily delivers a cap and a staple

Easy to use - just pull the trigger and drive it in

Gets the job done for a fraction of the cost of a pneumatic cap stapler

Best practice for securing roofing underlayment, felt and house wrap

Does the job without the additional hassel and expense of a hose, compressor and power requirements
Combination of cap and staples reduce the possibility of tearing roofing felt or house wrap

The Stinger 3/8 in. StaplePac contains 12 rolls of 168 collated plastic caps and 24 strips of 84 staples. StaplePac contains 1 in. collated caps and A11 3/8 in. staples. Cap fasteners are a recommended best practice for securing roofing felt and house wrap. The 3/8 in. StaplePac is for use with the Stinger CH38 or CH38A only.

Caps are a recommended installation best practice by housewrap and roofing underlayment manufacturers
Each 3/8 in. staplepac covers approximately 25 square feet

Caps help seal out moisture that can penetrate sidewall and roofing fabrics Combination of caps and staples reduces the possibility of tearing roofing felt or housewrap

Caps provide better holding power than a nail or staple alone

Fewer fasteners needed and fewer staple holes

Reduces lateral slippage